Mode Of Operation - Meister MOF1300-1 Originalbetriebsanleitung

5458020-Oberfraese_man 07.11.14 07:20 Seite 68
Safety after power failure in
continuous operation
If power fails while the router is in
continuous operation (lock button
pressed): Switch off the router
immediately! Do not set down with the
lock button engaged!
Risk of injury from uncontrolled
restarting! If power fails, release
lock button immediately!
9 – Mode of operation
Preparing the workpiece
Remove foreign bodies (nails, screws,
mortar residues, etc.) from the workpiece.
as they are a hazard for the router heads.
Risk of injury, if workpiece flies
out! Securely fasten workpiece!
Always clamp workpiece in a vice or
fasten to the workbench with cramps.
Ensure routing path is clear!
Basic work procedure
Risk of injury! Never work with
one hand only!
Direction of feed, when side-routing
Risk of injury from recoil! When
side-routing, maintain correct
direction of feed!
Fig. 9-1: When side-routing, the work piece
must always lie to the left of the router
head, facing in the direction of feed!
Do not rout backwards!
68
Trial routing
Good work results depend on
• correct speed and
• correct feed rate.
These values depend on the kind of
wood used, the shape of the router head
and the quantity of material removed.
Too low speeds and too fast a feed
cause rough routing edges. Too high
speeds and too slow a feed cause the
router head to overheat and routed
edges to discolour.
The following information will serve as a
guide to preselecting the speed on the
control (19):
Control setting
1
2 approx. 15200
3 approx. 18400
4 approx. 21600
5 approx. 24800
max.
Therefore: always carry out a test rout
on a waste piece of the wood used!
Plunge routing
Prerequirements:
• The router head must have cutting
tools on the underside also. The
router heads with guide wheel are not
suitable for plunge routing!
• The router head must not taper
upwards.
Fit template guide, centring point or
parallel fence, depending on the job.
Setting depth stop (see section „Setting
depth stop").
rpm
12000
28000