Components - Meister MOF1300-1 Originalbetriebsanleitung

5458020-Oberfraese_man 07.11.14 07:19 Seite 58
Noise emission/vibration
Noise emission
L : 89 dB(A)
pA
L : 100 dB(A)
WA
Measuring inaccuracy:
K : 3,0 dB(A)
pA
K : 3,0 dB(A)
WA
Hand/arm vibrations:
2
a : 5,4 m/s
h
Measuring inaccuracy K = 1,5 m/s
Noise/vibration information
Measured values determined in
accordance with EN 60745-1:2009.
The specified vibration emission value
was measured in accordance with a
normed test procedure and can be used
in order to compare one electrical tool
with another.
The specified vibration emission value
can also be used for an introductory
evaluation of the influence.
CAUTION! The vibration
emission value may fluctuate
from the specified value during use
of the power tool. These fluctuations
will depend on the way in which the
power tool is used.
Safety measures must be taken in
order to protect the operator. As a
result, the evaluation of the influence
must be made whilst taking account
of the actual conditions of use. (All
parts of the operating cycle must be
taken into account for this purpose.
This also includes times in which the
power tool is switched off and times
58
in which it is switched on, but is
running without load.)
CAUTION! A certain amount of
noise is unavoidable when using
this device. Ensure you carry out noise-
intensive work during permitted times.
Maintain the quiet periods and limit
your work to the absolute minimum.
CAUTION! The effects of noise
may cause damage to the
hearing. Only ever work with suitable
ear defenders. Anybody else in the
2
vicinity should thus also wear ear
defenders.
Rating plate
3 – Components
1 Power lead with power plug
2 Fine adjustment – depth stop
3 Handle (right)
4 Locking screw – depth stop
5 Depth stop with scale
6 Depth limiter
7 Dust hood
8 Base plate
9 Ventilation slits -motor housing
10 Handle (left)
11 Lock – handle angle
12 Locking lever
13 Router chuck with integrated collet
14 Fixing screw (2 x) for parallel fence
15 Connection chip extractor
16 ON/OFF switch
17 Lock button – continuous mode
18 Fixture (2 x) for parallel fence
19 Speed control
Note technical data on
rating plate!