Meister MOF1300-1 Originalbetriebsanleitung Seite 69

5458020-Oberfraese_man 07.11.14 07:20 Seite 69
Place router with base on
workpiece. The router
head must not come into
contact with the
workpiece yet!
Start router.
As soon as the set speed has been
reached, push router down so that the
router head enters the workpiece.
Feed the router carefully and evenly
forward.
At the end of the routing cut lift the
router again until the router head is clear
of the workpiece.
Switch off router.
Risk of injury from still rotating
router head! Wait until the motor
has come to a dead stop!
Only then should the router be removed
from the workpiece and put down.
Routing from the end face
Fit template guide, centring point or
parallel fence, depending on the job.
Setting cutting depth and lock (see
section „Setting cutting depth").
Place router with its base
at the start of the
workpiece. The router
head must not come into
contact with the
workpiece yet!
Start router.
As soon as the set speed has been
reached, feed the router carefully and
evenly through the workpiece.
At the end of the routing cut continue to
push router until the router head is clear
of the workpiece. Leave router base
resting on the workpiece!
Switch off router.
Risk of injury from still rotating
router head! Wait until the motor
has come to a dead stop!
Only then should the router be removed
from the workpiece and put down.
Copy-routing a prescribed shape
Fitting template guide (see section 7
– Installation and setting).
Making a template
Make template from robust material;
material thickness: min. 3 mm.
Fig. 9-2: Note the required offset between
template (1) and workpiece contour (2)!
This dimension is the distance between
the template guide (3) and the router
head blade (4).
Milling
Fig. 9-3: Guide the router so that the
template guide rests against the copy
template.
Routing straight cuts
Fitting parallel fence (see section 7 –
Installation and setting).
Fig. 9-4 (setting parallel fence): Loosen
grip screws. set desired distance
between parallel fence and router head.
Tighten handle screws tightly.
69