Meister MOF1300-1 Originalbetriebsanleitung Seite 66

5458020-Oberfraese_man 07.11.14 07:20 Seite 66
Fig. 7-15: Attach vacuum cleaner
hose to the nozzle of the dust hood
(if necessary, use adapter).
Setting the speed
Fig. 7-16: Setting the speed control
(1 = minimum, max. = maximum speed).
Fitting accessories
One of the following combinations is
necessary for each different type of job:
• Fitting template guide
• Fitting edge fence
• Fitting parallel fence
• Fitting curve fence
• Fitting centring point
Remove the parts not needed first!
Risk of injury! Before carrying out
any fitting work on the appliance,
unplug it from the power supply!
Fitting template guide
Fig. 7-17: Unscrew the two dust hood
screws downwards out of the base plate.
The nuts must remain in their sockets!
Insert template guide with the guide
66
edge pointing downwards.
Application example:
Machining a number of
workpieces of the same
shape, using a template
(mass production).
Prerequirement: only
router heads which can fit
through the template
guide without touching it
can be used!
Screw the two screws back into the
template guide.
Fitting edge fence
Application example:
Routing straight edges.
Fig. 7-18: Unscrew the two edge fence
screws (1) from the base plate.
Hold edge fence against the base plate
from below and fit using the two
screws.
Fitting parallel fence
Application example:
Rout parallel to a straight
workpiece edge.
Fig. 7-19: Loosen both fixing screws (1).
Insert guide bars (2) of the parallel fence
into the base plate.
Set distance and retighten fixing screws.
Fig. 7-20: If the distance between router
path and workpiece edge is particularly
great, use parallel fence. For this, using
the combination spanner, change the
guide bars round.
Fitting curve fence
Application example:
Machining rounded or
curved edges. Fit the
curve fence on the parallel
fence.