Meister MOF1300-1 Originalbetriebsanleitung Seite 65

5458020-Oberfraese_man 07.11.14 07:20 Seite 65
Fig. 7-5: Undo the locking lever.
Fig. 7-6: Undo locking screw (1). Allow
depth stop (2) to drop onto the depth
limiter (3).
Fig. 7-7: Push router (4) down until the
router head rests on the surface of the
work (5). In this position tighten the
locking screw (1).
Fig. 7-8: Release router (4) so that it
moves up again. The depth stop is now
set to 0 mm cutting depth.
Undo handle screw (1) and push depth
stop (2) up an amount equal to the
desired routing depth. In this position
tighten the locking screw (1).
The depth stop is now set to the desired
cutting depth.
The cutting depth can be precisely
adjusted using the fine adjustment.
The set cutting depth applies only to the
currently fitted router head! If router
heads with a different geometry are
used, the depth stop must be reset.
Set cutting depth and lock
Risk of injury! Always unplug
from mains before setting!
It is recommended to lock
the cutting depth if routing
is to be done to a specified
depth over the whole length
of the workpiece, starting
at the front edge.
Fitting router head.
Set depth stop (see above).
Fig. 7-12: Place router on the edge of
the workpiece and press down until the
depth stop (2) rests on the depth limiter (1).
Fig. 7-13: Lock at this setting with the
locking lever.
Setting the depth limiter
The depth limiter enables the set
dimension of the depth stop to be
reduced by 5 mm or 10 mm.
Set depth stop (see above).
Fig. 7-9: Zero setting.
Fig. 7-10: The set cutting depth is
reduced by 5 mm.
Fig. 7-11: The set cutting depth is
reduced by 10 mm.
Adjusting the handle angle
To enable ergonomic working, there
is a choice of 4 stages for the handle
angle.
Fig. 7-14: Hold router with both
handles. Undo lock left and right.
Change handle angle and release
the lock. Change handle angle until
the lock engages.
Risk of injury! Do not use router
if the lock is not engaged!
Connecting the chip extractor
To avoid inhaling harmful dust, always
work with the vacuum cleaner
connected up! Any commercially
available vacuum cleaner with a hose
long enough to ensure sufficient
freedom of movement is suitable.
65