Components - Meister MOF1200-1 Originalbetriebsanleitung

5458010-Oberfraese_man 05.02.19 08:55 Seite 57
Noise emission/vibration
Noise emission
L : 89 dB(A)
pA
L : 100 dB(A)
WA
Measuring inaccuracy:
K : 3,0 dB(A)
pA
K : 3,0 dB(A)
WA
Hand/arm vibrations:
2
a : 5,4 m/s
h
Measuring inaccuracy K = 1,5 m/s
Noise/vibration information
Measured values determined in
accordance with EN 60745-1:2009.
The specified vibration emission value
was measured in accordance with a
normed test procedure and can be used
in order to compare one electrical tool
with another.
The specified vibration emission value
can also be used for an introductory
evaluation of the influence.
CAUTION! The vibration
emission value may fluctuate
from the specified value during use
of the power tool. These fluctuations
will depend on the way in which the
power tool is used.
Safety measures must be taken in
order to protect the operator. As a
result, the evaluation of the influence
must be made whilst taking account
of the actual conditions of use. (All
parts of the operating cycle must be
taken into account for this purpose.
This also includes times in which the
power tool is switched off and times
in which it is switched on, but is
running without load.)
CAUTION! A certain amount of
noise is unavoidable when using
this device. Ensure you carry out noise-
intensive work during permitted times.
Maintain the quiet periods and limit
your work to the absolute minimum.
CAUTION! The effects of noise
may cause damage to the
hearing. Only ever work with suitable
ear defenders. Anybody else in the
2
vicinity should thus also wear ear
defenders.
Rating plate
3 – Components
1 Power cable with mains plug
2 Safety switch
3 Handle (right)
4 Spindle lock
5 Fixing screws (x 2) for rip fence
6 Base plate
7 Mounting rails (2 x) for rip fence
8 Depth limiter
9 Depth stop locking screw
10 Depth stop with scale
11 Depth stop adjustment setting
12 Speed control
13 Engine housing ventilation slots
14 Locking lever
15 Handle (left)
16 Milling chuck with integrated collet
chuck
17 Chip extraction port with adapter
18 On/off switch
Note technical data on
rating plate!
57