Turning On The Projector - NEC PH3501QL Installationsanleitung

4-2. Turning on the Projector

Please contact your dealer/distributor to connect the power cable.
Preparation:
• Connect the power cable to the projector. (→ page 24)
• Supply AC power to the projector.
NOTE:
• Turn off the projector power switch and light power switch to the projector when cutting AC power to the projector. Shutting down
the AC power while the projector power switch and light power switch is on will damage the projector.
• Turning on and off the projector involves a two-step operation; the "projector power switch and light power switch" and the
"POWER button" (POWER ON and OFF on the remote control).
Turning power on. (See this page)
1. Turn on the "projector power switch and light power switch" of the projector.
Your projector is set in a standby state.
2. Press the (POWER) button on the projector cabinet or the POWER ON button on the remote control.
Your projector is turn on.
Turning power off. (→ page 85)
1. Press the (POWER) button on the projector cabinet or the POWER OFF button on the remote control.
The confirmation message will be displayed.
2. Press the (POWER) button or the POWER OFF button again.
Your projector is set in a standby state.
3. Turn off the "projector power switch and light power switch" of the projector.
Your projector is turned off.
1. Remove the lens cap.
2. Insert the administrator key vertically, and turn it to the right.
The administrator key can no longer be removed. The projector will not function unless the administrator key is
inserted.
Administrator key
Administrator switch
4. Projector Adjustment and Connecting
70