Procedure For Connecting The Power Cable (C1 Connection) - NEC PH3501QL Installationsanleitung

1-8-2. Procedure for connecting the power cable (C1 connection)

Preparation:
Phillips-head screwdriver (No. 2), service key (projector accessory)
WARNING
• Before connecting the power cable, make sure that the AC power supply is disconnected. Otherwise a fire or
electric shock may occur.
• High leakage current flows. Do NOT connect the power supply before grounding connection.
1. Remove the plate inlet.
Remove the plate inlet by loosening the fixing screws (at six points).
In Europe, replace it with the supplied ⌀35 plate inlet.
Plate Inlet
2. Pass the power cable through the cable hole of the plate.
If you use the supplied ⌀35 plate inlet, pass the power cable through a commercially available cable stopper
and then insert it into the cable hole.
Cable stopper
1. Before Setting Up Your Projector
31