Installation For Free Tilting Or Portrait Projecting - NEC PH3501QL Installationsanleitung

7-7-3. Installation for free tilting or portrait projecting

This projector can be set to any angle within a vertical 360° range. how-
ever, it cannot be installed with right or left slant.
If you install the projector vertically you can project screens from your
computer and other sources in portrait orientation.
• Be sure to install the device with the side where the Connection termi-
nals and Controls/Indicator Panel are located facing the top.
• Angle to display all the screens such as the on-screen menu can be
changed by the menu [SETUP] → [MENU (2)] → [MENU ANGLE].
Precautions for the portrait insntallation
• Do not simply set the projector vertically on the floor or on a table. The projector may fall over, resulting in injury,
damage, malfunction or hazardous laser radiation exposure. Also the intake vent may become blocked causing
the unit's internal temperature to rise resulting in malfunction and risk of fire.
• For portrait installation the intake vents must be installed at the top and bottom. To ensure air flow to the bottom
intake vent, a rack to support the unit is necessary. Please hire an installation service provider (for a fee) to
make a custom portrait projection stand.
• When installed in portrait orientation the projector can be tilted forward or backward
within a range of ± 10°. Tilting the projector forward or backward outside of this range, or tilting it to the left or to
the right could cause it to malfunction.
• To ensure air flow, maintain 60 cm/23.6" of space between the intake
vent and the installation surface.
(NOTE) In the figure to the right there is plenty of space behind, above,
and on either side of the projector unit.
115
7. Appendix