NEC PH3501QL Installationsanleitung Seite 45

AC Power Work Specifications
AC power supply equipment
Do not use any voltage other than those shown below for the AC power supply connected to the projector.
200–240V AC, single phase, power, 50/60Hz
AC power supply cable for the projector
The projector is equipped with an IEC60320-C14 inlet to connect an AC power supply cable. Use an IEC60320-C13
compliant AC power cable connector and ensure that the connector meets the following current capacity specifications.
Power supply voltage
AC 200–240V
Furthermore, use plugs, cables, and connectors that are suitable for the regulations of the country of installation, as
shown in the following table.
NOTE:
• For users in North America
Use a power cable no longer than 4.5m/14.76 ft according to National Electrical Code.
• For UK only: In UK, a BS approved power cable with moulded plug has a black (10 Amps) fuse installed for use with this equip-
ment. If a power cable is not supplied with this equipment, please contact your supplier.
Germany
Plug
CEE 7
USA
Plug
NEMA 6-15P
Projector input current
4.9A
Plug
Cable
H05VV-F 3 x 1 mm
Cable
SJT 3 x AWG 16
19
1. Before Setting Up Your Projector
Power cable current capacity
10A or higher
Cable
Connector
IEC60320 C13
2
IEC60320 C13
Connector
Connector