Power Supply - NEC PH3501QL Installationsanleitung

WARNING
Do not do it
1. Do not use the projector with the supplied lens cap
or equivalent while the projector is operating. This
may cause the lens cap to heat up and deform or
melt.
2. Do not place any objects, which are easily affected
by heat, in front of the projector lens. Doing so could
lead to the object melting from the heat that is emit-
ted from the light output.
It is possible to vertically set up this device at 360 degrees.
Do not use the projector with it leaning to the left and right.
This may result in a malfunction, however, portrait instal-
lation is possible. Please read the warnings concerning
portrait orientation before setting the projector in portrait
orientation.

Power Supply

1. Consult your distributor for installing the power cable
to the projector. DO NOT install the power cable by
yourself.Doing so may cause a fire or electric shock.
The projector is so designed that it operates with the
power supply voltage described below.
For C1 connection
(When the AC power to the projector power supply and
the light power supply is provided by a single cable)
• AC 200V-240V single phase 50/60Hz
For C2 connection
(When the AC power to the projector power supply
and the light power supply is provided by separate
cables)
• AC 200V-240V single phase 50/60Hz (projector
power supply)
• AC 200V-240V single phase 50/60Hz (light power
supply)
Ensure that your power supply fits this requirement
before attempting to use your projector.
2. The power cable is not included with the projector.
Ask your distributor for the power cable to select and
purchase. Use a power cable that meets the standards
and power supply voltage of the country where you
are using the projector.
Refer to "1-8. Connecting the Power Cable" (→ page
24) for details on connecting the power cable.
3. Handle the power cable carefully. A damaged or
frayed power cable can cause electric shock or fire.
• Do not bend or tug the power cable excessively.
• Do not place the power cable under the projector,
or any heavy object.
• Do not cover the power cable with other soft ma-
terials such as rugs.
• Do not heat the power cable.
4. Placing the power cable and the signal cable closely
to each other can cause beat noise. If this happens,
keep the two separated so that beat noise is not
generated.
Beat noise is corruption of the picture often seen as
a rolling band moving through the image.
5. Do not touch the projector during a thunder storm.
Doing so can cause electrical shock or fire.
6. When installed on the ceiling, install the breaker in a
location that is easy to reach by hand.
CAUTION
This equipment is designed to be used in the condition
of the power cable connected to earth. If the power
cable is not connected to the earth, it may cause
electric shock. Please make sure the power cable is
earthed properly.
iii
Important Information