Connecting The Cable - NEC PH3501QL Installationsanleitung

Connecting the cable

In order to attach the power cable to the connector block, connect the wires using the following procedure such that
the individual wires cannot directly touch each other.
1. Remove the power cable sleeves from the terminals to
ensure that the sleeves are not pinched by the terminal
attachment screw.
Pull back the sleeves from the terminal area before fastening
the screw to prevent the sleeves from being pinched.
2. Attach the sleeves after tightening the screw.
Tighten the fixing screw to the designated torque.
Use sleeves and secure the insulation to ensure that terminals
do not touch each other. If the cables are attached to the
power supply terminal without using sleeves, there is a risk of
the terminals touching each other as shown in the photograph
on the right.
1. Before Setting Up Your Projector
29
Sleeves