D-Link DES-3326 Bedienungsanleitung Seite 65

DES-3326 Layer 3 Fast Ethernet Switch User's Guide
The COMMAND field specifies an operation according the following table:
The field VERSION contains the protocol version number (1 in this case), and is used by the receiver to
verify which version of RIP the packet was sent from.
RIP 1 Message
RIP is not limited to TCP/IP. Its address format can support up to 14 octets (when using IP, the
remaining 10 octets must be zeros). Other network protocol suites can be specified in the Family of
Source Network field (IP has a value of 2). This will determine how the address field is interpreted.
RIP specifies that the IP address 0.0.0.0 denotes a default route.
The distances, measured in router hops are entered in the Distance to Source Network, and Distance to
Destination Network fields.
RIP 1 Route Interpretation
RIP was designed to be used with classed address schemes, and does not include an explicit subnet
mask. An extension to version 1 does allow routers to exchange subnetted addresses, but only if the
subnet mask used by the network is the same as the subnet mask used by the address. This means the
RIP version 1 cannot be used to propagate classless addresses.
Routers running RIP version 1 must send different update messages for each IP interface to which it is
connected. Interfaces that use the same subnet mask as the router's network can contain subnetted
routes, other interfaces cannot. The router will then advertise only a single route to the network.
RIP Version 2 Extensions
RIP version 2 includes an explicit subnet mask entry, so RIP version 2 can be used to propagate
variable length subnet addresses or CIDR classless addresses. RIP version 2 also adds an explicit next
hop entry, which speeds convergence and helps prevent the formation of routing loops.
RIP2 Message Format
The message format used with RIP2 is an extension of the RIP1 format:
Command
1
Request for partial or full routing information
2
Response containing network-distance pairs from
sender's routing table
3
Turn on trace mode (obsolete)
4
Turn off trace mode (obsolete)
5
Reserved for Sun Microsystem's internal use
9
Update Request
10
Update Response
11
Update Acknowledgement
Table 5-12. RIP Command Codes
Meaning
65