D-Link DES-3326 Bedienungsanleitung Seite 216

To edit a RIP configuration, click the Hand icon.
The following fields can be set:
Figure 7-29. Setup RIP window
Figure 7-30. Setup RIP – Edit window
Parameter Description
Subnet Name
TX Mode
<Disabled>
RX Mode
<Disabled>
Password
Authentication
DES-3326 Layer 3 Fast Ethernet Switch User's Guide
The name of the IP interface on
which RIP is to be setup. This
interface must
configured on the Switch.
Toggle among Disabled, V1 Only, V1
Compatible, and V2 Only. This entry
specifies which version of the RIP
protocol will be used to transmit RIP
packets. Disabled
transmission of RIP packets.
Toggle among Disabled, V1 Only, V2
Only, and V1 and V2. This entry
specifies which version of the RIP
protocol will be used to interpret
received RIP packets.
prevents the reception
packets.
A password to
authenticate
between routers on the network.
Toggle between
Enabled to specify that routers on
the network should us the Password
above to authenticate router table
exchanges.
216
be previously
prevents the
Disabled
of RIP
be used to
communication
Disabled and