D-Link DES-3326 Bedienungsanleitung Seite 131

DES-3326 Layer 3 Fast Ethernet Switch User's Guide
Area Aggregation Configuration
Area Aggregation allows all of the routing information that may be contained within an area to be
aggregated into a summary LSDB advertisement of just the network address and subnet mask. This
allows for a reduction in the volume of LSDB advertisement traffic as well as a reduction in the memory
overhead in the switch used to maintain routing tables.
To aggregate routing information contained within an OSPF area, highlight Area Aggregation
Configuration from the Setup OSPF menu and press Enter.
The following fields can be set:
Action:<Add/Modify
>
Area ID:[
Network
]
Network
Netmask:[
Status
Figure 6-48. Area Aggregation Configuration screen
Parameter
This field can be toggled using the space bar between
Add/Modify and Delete. Add/Modify allows for the creation
of a new OSPF Area Aggregation or changes to an existing
OSPF Area Aggregation. Delete allows for the deletion of an
existing OSPF Area Aggregation.
] Allows the entry the OSPF Area ID for which the routing
information will be aggregated. This Area ID must be
previously defined on the switch.
Number:[
Sometimes called the Network Address. The 32-bit number
in the form of an IP address that uniquely identifies the
network that corresponds to the OSPF Area above.
This is the netmask associated with the Network Number
above.
]
Displays the current status (UP or
DOWN) of the corresponding OSPF
Virtual Interface.
Description
131