D-Link DES-3326 Bedienungsanleitung Seite 224

Open the Configuration menu, select Multicasting, and click IGMP Snooping Settings:
To configure IGMP Snooping:
The following fields can be set:
IEEE 802.1Q Multicast Forwarding
To edit the IEEE802.1 Multicast Forwarding settings:
Figure 7-38. IGMP Control Setup window
Parameter
VID
State <Disabled>
Query
Max Response
Robustness Var
DES-3326 Layer 3 Fast Ethernet Switch User's Guide
Description
Allows the entry of the VLAN ID (VID)
for which IGMP Snooping is to be
configured.
This field can be switched using the
pull-down menu between Disabled
and Enabled. This is used to enable
or disable IGMP Snooping for the
specified VID.
Allows the entry of a value between 1
and 65535 seconds, with a default of
125 seconds. This
length of time between sending IGMP
queries.
Sets the maximum amount of time
allowed before sending an IGMP
response report. A value between 1
and 25 seconds can be entered, with
a default of 10 seconds.
A tuning variable to allow for sub-
networks that are expected to lose a
large number of packets. A value
between 2 and 255 can be entered,
with larger values being specified for
sub-networks that are expected to
lose larger numbers of packets.
224
specifies the