D-Link DES-3326 Bedienungsanleitung Seite 230

The following fields can be set:
Interface
Name<System>
IP Address
Probe
<10>
Nbr Report Timer
<35>
Route Cost <1>
State <Disabled>
PIM-DM Settings
To configure PIMDM for an IP interface:
Click the PIMDM Interface Configuration link:
Parameter
Allows the entry of the name of the IP interface for which
DVMRP is to be configured. This must be a previously
defined IP interface.
Displays the IP address corresponding to the IP Interface
name entered above.
Interval
This field allows an entry between 0 and 65,535 seconds
and defines the interval between 'probes'. The default is
10.
This field allows an entry between 1 and 65,535 seconds
and defines the time period for DVMRP will hold Neighbor
Router reports before issuing poison route messages. The
default is 35 seconds.
This field allows an entry between 1 and 255 and defines
the route cost for the IP interface. The DVMRP route cost
is a relative number that represents the real cost of using
this route in the construction of a multicast delivery tree.
It is similar to, but not defined as, the hop count in RIP.
The default cost is 1.
This field can be toggled between Enabled and Disabled
and enables or disables DVMRP for the IP interface. The
default is Disabled.
Figure 7-45. PIM-DM Interface Configuration window
DES-3326 Layer 3 Fast Ethernet Switch User's Guide
Description
230