D-Link DES-3326 Bedienungsanleitung Seite 232

The target port is the port where information will be duplicated and sent for capture and network
analysis. This is the port where a network analyzer would be attached to capture packets duplicated
from the source port.
To select the source port(s) for mirroring, click the Port Mirroring Settings link on the Mirroring menu
(under Configuration):
Up to 25 entries can be made to the port mirroring table, but it should be noted that a faster port (a
1000 Mbps Gigabit Ethernet port, for example) should not be mirrored to a slower port (one of the 24
100 Mbps Fast Ethernet port), because many packets will be dropped.
The following fields can be set:
Figure 7-46. Target Port Selection window
Figure 7-47. Setup Mirror Port Config window
Parameter
Source Port
Direction <Ingress>
DES-3326 Layer 3 Fast Ethernet Switch User's Guide
Description
Allows the entry of the port number
of the port to be mirrored. This port
is the source of the packets to be
duplicated and forwarded to the
Target port.
This field can be toggled between
Either, Ingress and Egress. Ingress
mirrors only received packets, while
Egress mirrors only
packets.
232
transmitted