Multicasting - D-Link DES-3326 Bedienungsanleitung

DES-3326 Layer 3 Fast Ethernet Switch User's Guide
The following fields can be set or are displayed:

Multicasting

Layer 2 Multicast Setup
The following menus are used to setup the switch's Layer 2 multicasting features.
IGMP Snooping Settings
To configure IGMP Snooping:
Figure 7-37. Route Redistribution Settings window
Parameter
Source Protocol
Dest. Protocol
Metric Type
Metric
Description
Allows the selection of the protocol of
the source device. Available choices
are RIP, OSPF, or Static.
Allows the selection of the protocol of
the destination device.
choices are RIP and OSPF.
Allows the selection of one of two
methods for calculating the metric
value. Type-1 calculates the metric
(for RIP to OSPF) by adding the
destination's interface cost to the
metric entered in the Metric field.
Type-2 uses the metric entered in the
Metric field without change. This
field applies only
destination field is OSPF.
Allows the entry of an OSPF interface
cost. This is analogous to a Hop
Count in the RIP routing protocol.
223
Available
when the