Program G - Pax 1; Program H - Pax 2 - Nussbaum BM 11 Bedienungsanleitung

5.3.2.7 Program G - PAX 1

For PAX wheels with adhesive wheel weights below the
rim edge and on the inner side of the rim
2 4
" i
Rim diameter and rim width are displayed in MILLI-
METERS. LED for PAX is light.
BM 10-2 / 11 / 20-2 / 30-2
The distance between machine and rim is automatical-
ly detected.
Extend the outside gauge to the position 2 and hold in
place until an audible signal is heard.
Move the inside gauge directly to position 3 and hold
until another audible signal is heard.
Return the gauge to the home position.
Another signal indicates that it is in the home position.
BM 10-2
Enter rim diameter manually via the +/- button.
!
The actual value is automatically stored when ano-
ther button is pressed or the wheel guard is closed to
start the measuring run.
BM 11 / 20-2 / 30-2 / 40-2 / 50-2
The rim diameter is automatically detected together
with the distance by the inner gauge arm.
BM 10-2 / 11 / 20-2 / 30-2
The rim width is preset depending on distance and dia-
meter. Out of that the value for the rim width does only
has manually to be corrected a little or not entered at
all. The preset value for the rim width is displayed after
distance and diameter have been stored. The value
can be corrected by pressing the +/- button.
Measure the nominal rim width using the rim width gau-
ge or check the dimensions stamped on the rim.
Enter the value manually via the +/- buttons.
!
The actual value is automatically stored when ano-
ther button is pressed or the wheel guard is closed
to start the measuring run.
1 689 979 917N 03.07.2013
BM 40-2 / 50-2
Extend the outside gauge to the position 4 and hold in
place until an audible signal is heard.
Replace the gauge back into its home position.
Wheel data can also be entered by using the +/- keys.

5.3.2.8 Program H - PAX 2

For PAX wheels with adhesive wheel weights below the
rim edge and on the inner side of the rim.
2
3
Rim diameter and rim width are displayed in MILLIME-
TERS LED for PAX is light.
BM 10-2 / 11 / 20-2 / 30-2 / 40-2 / 50-2
The distance between machine and rim is automatical-
ly detected.
Extend the outside gauge to the position 2 and hold in
place until an audible signal is heard.
Move the inside gauge directly to position 3 and hold
until another audible signal is heard.
Return the gauge to the home position.
Another signal indicates that it is in the home position.
BM 10-2
Enter rim diameter manually via the +/- button.
!
The actual value is automatically stored when ano-
ther button is pressed or the wheel guard is closed to
start the measuring run.
BM 11 / 20-2 / 30-2 / 40-2 / 50-2
The rim diameter is automatically detected together
with the distance by the inner gauge arm.
!
The rim width is not of meaning in this balancing pro-
gram.
55