Installing The Battery; Charging The Battery; Charging Using The Charging Station - Cleanmaxx QQ2L Gebrauchsanleitung

Installing the battery

Charging the battery

The charging state of the battery can be read on the battery symbol on the display. Three
bars indicate a full battery and one bar indicates an almost empty battery.
Before the fi rst use, it takes about 6 to 8 hours to completely charge an empty battery, later
about 3.5 hours. The battery can be charged in two ways: through the charging station or
directly using the power supply unit.
You can remove the Euro plug from the power supply unit and attach another
adapter (not included in the scope of supply). The power supply unit is suited for an
input voltage of 100 - 240 V~, 50/60 Hz.
• Removing the plug: Press the PUSH key and turn the plug clockwise a bit.
• Attaching the plug: Insert it into the power supply unit and turn it clockwise
until it audibly engages.

Charging using the charging station

1. Look for a suitable location for the charging station.
The charging station is best placed on a fi rm surface and in an area to which the appliance
has a free return path at the end of the cleaning cycle. About 50 cm clearance must
be in front of the charging station.
Place the bottom metal plate of the charging station along a wall or another im-
movable object to prevent the charging station from sliding during docking.
06709_DE-GB-FR-NL_V2.indb 25 06709_DE-GB-FR-NL_V2.indb 25
1. Make sure the appliance is not connected to the power
mains.
2. The battery compartment is located on the bottom of the
appliance. Open it by pressing both catches on the battery
compartment cover and then pull it up.
3. Remove the battery compartment cover.
4. Lay the supplied battery into the battery compartment so
that the fabric band of the battery is at the top and apply its
metal poles to the contacts in the battery compartment
(the battery can be removed from the compartment by the
fabric band).
5. Close the battery compartment
25
cover: First press in the catches of
the cover (1) and then press the
cover into the closures (2) until it
audibly locks.
04.02.11 11:12 04.02.11 11:12