Charging Station; Charging Up The Battery - Cleanmaxx 00142 Gebrauchsanleitung

EN

Charging station

Charging Up the Battery

CAUTION!
■ The battery may only be charged using the charging station (23) or the mains adapt-
er (21) which is supplied with the device. Do not use the mains adapter (21) or the
charging station (23) to charge other batteries.
■ The cordless vacuum cleaner must be switched off before charging takes place.
■ Store the cordless vacuum cleaner with the frame (6) in the charging station (23).
Connect the charging station (23) to the mains power. Do not allow the battery to run
down too low so that it is not damaged.
■ It is essential that you charge up the battery fully before you fi rst use the de-
vice in order to achieve the maximum charging capacity. If the battery is fully
discharged during use, it must be fully charged up again before it is next used.
1. Place the assembled charging station (23) in a dry location near to a properly in-
stalled, easily accessible plug socket.
2. First plug the barrel connector on the mains cable into the socket (22) of the charging
station (23) and then connect the mains adapter (21) to the plug socket.
3. Hook the frame (6) into the charging station (23). The battery control lamps (9) will
fl ash during the charging process.
4. If all three battery control lamps (9) light up constantly, the battery is fully charged up.
00142_de-en-fr-nl_A5_V1.indb 20 00142_de-en-fr-nl_A5_V1.indb 20
20
• Removing: Press the release button (2) on the side of the
handle (3) and pull out the cordless vacuum cleaner.
• Assembling: Plug together the two parts of the charging
station (23) (see picture).
• Taking apart: Press the release button (20) at the bottom
on the back and pull both parts of the charging station (23)
apart at the same time.
• On the back of the charging station (23) there are holders
for storing the crevice and brush nozzle (19). Place the
crevice nozzle (18) in the top holder and the brush noz-
zle (19) in the bottom holder.
To pull out the brush nozzle (19), grip and pull the
bristles at the top end.
• Hook the frame (6) into the charging station (23).
19.09.2016 12:36:55 19.09.2016 12:36:55