Before Initial Use; Charging Up The Battery; Attaching The Wall Bracket - Cleanmaxx PC-P011E Bedienungsanleitung

Before Initial Use

• Before using the device, remove all packaging materials and any labels that may be
on the device and are used for protection during transportation or for advertising.
Never remove the rating plate and any possible warnings!
• Charge up the battery (D) (see the "Charging Up the Battery" chapter).
• Attach the wall bracket (see the "Attaching the Wall Bracket" chapter).

Charging Up the Battery

PLEASE NOTE!
■ It is essential that you charge up the battery fully before you fi rst use the de-
vice in order to achieve the maximum charging capacity. If the battery is fully
discharged during use, it must be fully charged up again before it is next used.
■ Before inserting the battery, check whether the contacts are clean and clean them if
necessary.
• First plug the barrel connector of the mains adapter (E) into the connecting sock-
et (10) on the motor unit (F) and then connect the mains adapter to a plug socket. The
Level I operating lamp (6) fl ashes. The battery is being charged.
• If the operating lamp is permanently lit, the battery is fully charged.
• First disconnect the mains adapter from the mains power and then disconnect the
barrel connector from the motor unit.

Attaching the Wall Bracket

PLEASE NOTE!
■ Use the fastening material supplied to hang up the wall bracket. If you are unsure
whether the fastening material supplied is suitable for your wall, seek advice from a
specialist stockist.
■ Hang the wall bracket in a secure and solid place.
■ Before drilling, ensure that there are no pipes or cables behind the intended drilling
point.
1. Place the wall bracket (C) against the wall and mark out two drill holes (at the top
and bottom).
2. Drill holes into the wall and place dowels in them.
3. Screw the wall bracket onto the wall.
09196_09197_Inlay_DE-EN-FR-NL_A5_V2.indb 19 09196_09197_Inlay_DE-EN-FR-NL_A5_V2.indb 19
19 EN
22.05.2019 12:09:58 22.05.2019 12:09:58