Wall Mounting Bracket; Charging Up The Battery - Cleanmaxx 05767 Gebrauchsanleitung

EN
WALL MOUNTING
BRACKET
Please Note!
■
Make sure that the surface on which
the wall mounting bracket is mounted
is stable and that screws and anchors
which are suitable for the wall are
used. Seek advice from a specialist
retailer if in doubt.
■
Before drilling, ensure that there are
no pipes or cables behind the intend-
ed drilling point.
The device can be stored in the wall
mounting bracket (B) and charged up
there for its next use (Picture I).
The wall mounting bracket can be
screwed onto the wall. The items sup-
plied include 2 screws and anchors to
allow you to do this.
 
Ideally attach the wall mounting
bracket near to an easily accessi-
ble plug socket so that the device
can be charged.
The cord of the connecting
cable (D) can be tucked in on the
small hook on the wall mounting
bracket.
Screwing On the Wall Mounting
Bracket
1. Place the wall mounting bracket
straight against the wall and mark out
two drill holes.
2. Drill holes into the wall and place
anchors in them.
3. Screw on the wall mounting bracket.
16
Inserting the Motor Unit
Insert the motor unit (E) into the wall
mounting bracket so that the suction
opening (12) is pointing downwards and
the recess over the battery (C) fi ts on
the hook of the wall mounting bracket
(Picture I).
CHARGING UP THE
BATTERY
Please Note!
■
Only connect the mains adapter to a
plug socket that is properly installed
and matches its technical data. The
plug socket must be readily accessible
after connection so that the con-
nection to the mains can quickly be
isolated.
■
Only use suitable extension cables
whose technical data is the same as
that of the mains adapter.
■
Pull the mains adapter out of the plug
socket if an error occurs during charg-
ing or before a thunderstorm.
■
It is essential that you charge up the
battery fully before you fi rst use the
device in order to achieve the maxi-
mum charging capacity. If the battery
is fully discharged during use, it must
be fully charged up again before it is
next used.
The battery (C) must be inserted in the
motor unit (E) for charging.
1. Plug the barrel connector of the
connecting cable (D) into the charging
socket (11).
2. Connect the mains adapter to a plug
socket.
The charge control lamp (7) starts to
fl ash and the battery is charging.
If the charge control lamp is perma-
nently lit, the battery is fully charged.