Charging Up The Battery; Assembly; Attaching / Removing Nozzles; Removing / Inserting The Dust Bin - Cleanmaxx 01169 Gebrauchsanleitung

EN

Charging Up the Battery

PLEASE NOTE!
■ Only connect the mains adapter to a plug socket that is properly installed and match-
es its technical data. The plug socket must be readily accessible after connection so
that the connection to the mains can quickly be isolated.
■ Pull the mains adapter out of the plug socket if an error occurs during charging or
before a thunderstorm.
■ Risk of short-circuit! Do not insert any conductive objects (e. g. screwdrivers or
similar) into the connector jack of the motor unit.
■ Pull the mains adapter out of the socket if you do not use it for a prolonged period
of time.
■ It is essential that you charge up the battery fully before you fi rst use the de-
vice in order to achieve the maximum charging capacity. If the battery is fully
discharged during use, it must be fully charged up again before it is next used.
1. First connect the mains adapter to the connector jack in the motor unit (if applicable,
hang the motor unit in the wall bracket) and then connect it to a properly installed,
easily accessible socket. The charge control light will now light up.
2. Let the rechargeable battery of the device charge for approx. 10 – 14 hours in order
to reach the maximum charge. The charge control light will illuminate as long as the
device is connected to the mains supply.
3. Disconnect the adapter from the mains power fi rst and then from the device.

Assembly

Attaching / Removing Nozzles

• Plug the nozzle you want as far as it will go into the suction opening on the front of
the dust bin and check that it fi ts securely.
• To remove a nozzle, pull it out of the suction opening.

Removing / inserting the dust bin

01169_01279_01578_02223_04380_05784_08862_DE-EN-FR-NL_A5_V8.1.indb 20 01169_01279_01578_02223_04380_05784_08862_DE-EN-FR-NL_A5_V8.1.indb 20
20
• Removal: Hold the device with the dust bin down and
take hold of the dust bin. Press the release button and
remove the dust bin from the motor unit.
• Insertion: A catch is located on the bottom side of the
motor unit. Insert it in the corresponding slit in the dust
bin. Then push the two parts of the device together at the
top until the locking mechanism audibly locks into place.
If necessary, the release button must be depressed in
the process. Then check whether the dust bin is properly
seated.
09.11.2021 17:21:26 09.11.2021 17:21:26