Charging Up The Battery; Attaching The Wall Mounting Bracket - Cleanmaxx VC1806 Bedienungsanleitung

Cordless Handheld and Floor Vacuum Cleaner
■ The device should only be used if it has
been fully and correctly assembled!
The dust container and the filters
must be inserted and must not be
damaged! If the dirt were to get inside
the motor unit, this could damage the
motor.
■ The device must be switched off when
the power supply is pulled out or inserted
into the plug socket. Always pull the
power supply and never the mains cable
to disconnect the device from the mains
power!
■ Do not place heavy objects on the de­
vice or the connecting cable.
■ Protect the device from heat, flames, ex­
treme temperatures, persistent moisture
and impacts.
■ Use only original accessories from the
manufacturer in order to guarantee that
there is no interference that may prevent
the device from working and to avoid
possible damage. The LEDs cannot be
replaced.
CHARGING UP THE
BATTERY
Please Note!
■ Charge up the battery fully before
you first use the device in order
to achieve the maximum charging
capacity. If the battery is discharged
during use, it should be fully charged up
again before it is next used.
■ Only connect the power supply to a
plug socket that is properly installed
and matches its technical data. The plug
socket must be readily accessible after
connection so that the connection to the
mains can quickly be isolated.
■ Only use suitable extension cables whose
technical data is the same as that of the
power supply.
11052_Inlay_DE-EN-FR-NL_A5_V1.indb 15 11052_Inlay_DE-EN-FR-NL_A5_V1.indb 15
■ Pull the power supply out of the plug
socket if an error occurs during charging
or before a thunderstorm.
1. Plug the barrel connector of the
connecting cable (F) into the charging
socket (15).
2. Connect the power supply to a plug
socket.
The charge control lamps (16) start to
flash and the battery is charging.
If all charge control lamps are constantly
lit, the battery is fully charged.
3. First disconnect the power supply from
the mains power and then disconnect
the barrel connector from the device.
ATTACHING THE WALL
MOUNTING BRACKET
Please Note!
■ Use the fixings which are also supplied
to hang up the wall mounting bracket.
If you are unsure whether the fixings
supplied are suitable for the wall, seek
advice from a specialist retailer.
■ Hang the wall mounting bracket in a se­
cure and fixed position.
■ Before drilling, ensure that there are
no pipes or power cables behind the
intended drilling point.
1. Place the wall mounting bracket (G)
against the wall and mark out two drill
holes (at the top and bottom).
2. Drill holes into the wall and place
anchors in them.
3. Screw the wall mounting bracket onto
the wall.
EN
15
23.02.2023 15:36:28 23.02.2023 15:36:28