Troubleshooting Table - Scheppach HS730 Bedienungsanleitung

7. Install a new or sharpened saw blade.
Pay attention to the correct running direction of the
saw blade: The arrow on the safety guard and the
arrow on the saw blade must show to the same di-
rection.
8. Reinstall the front saw blade flange and the
washer
9. Secure the saw blade using the screw.
10. Slide the both washers on the support pin
(fig. 14, A).
11. Lift the tilt table and guide the support pin into the
hole (fig. 14, B).
12. Install the cover plate (fig. 15, A) in its guide at
the same time.
A second person may be required.
13. Plug the spring cotter pins through the support
pin (fig. 11, A).
14. Remove the locking pin (fig. 12, A).
Replacing the plastics insert
Immediately replace the worn or damaged plastics
inserts (fig. 1, 11).
1. Loosen the screws of the plastics insert and re-
move them.
2. Insert a new plastic insert and screw it tightly in
place.
Warning: In the interests of operational safety, always switch off the saw and remove the mains plug before car-
rying out maintenance work.
Problem Possible Cause
1. Saw blade gets
loose after turning Fastening nut tightened insufficiently
off the motor
a) Failiure main fuse
b) Extension cable defect
2. Motor does not
start
c) Connections on the motor or switch
defect
d) Motor or switch defect
3. Wrong rotational
Changed phase
direction
a) Cross section of extension cable is too
4. No motor output,
low
turns off automati-
cally
b) Overload by dull saw blade
a) Dull saw blade
5. Burns on the cut-
ting surface
b) Wrong saw blade
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste elec-
trical and electronic equipment. Improper handling
of waste equipment may have negative consequenc-
es for the environment and human health due to po-
tentially hazardous substances that are often con-
tained in electrical and electronic equipment. By
properly disposing of this product, you are also con-
tributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.

Troubleshooting table

Help
Tighten fastening nut, M20 left-handed
thread
a) Check the mains fuse.
b) Replace the extension cable
c) Have to checked by an electrician
d) Have to checked by an electrician
Change the phase (see fig. 10)
a) See "electric connection"
b) Insert a sharpened saw blade
a) Insert a sharpened saw blade
b) Insert correct saw blade
23 I 60