PeakTech 1145 Bedienungsanleitung Seite 56

AC: Displayed on the screen in the form of "
component is cut and only AC component is displayed.
DC : Displayed on the screen in the form of "
including a DC component is displayed.
Ground : Displayed on the screen in the form of "
amplifier is grounded.
3) Probe . (X1 / x10 / x100 / x1000)
Set this to match your probe attenuation factor to make the vertical scale readout correct
x1 : when 1:1 probe is used or signal is directly connected to the coaxial cable, x1 is selected
x10 : when 10:1 probe is used , x10 is selected.
x100 : when 100:1 probe is used, x100 is selected.
x1000 : when 1000:1 probe is used , x1000 is selected.
4) Position Set To 0
Set the offset to 0V. Offset performs a function similar to the vertical position knob.
5.3. MATH
~
". An input signal is connected to the amplifier via a capacitor. Its DC
" . An input is directly connected to the amplifier, and the signal
" . An input signal is separated and the input of the vertical
POSITION
The displayed waveform can be moved up and down by the position knob.
When the knob moves to right, waveform moves down and when the knob
moves to left, waveform moves up.
When this switch is pressed, arithmetic and advanced function are
displayed.
-14-