PeakTech 1145 Bedienungsanleitung Seite 44

2. Introduction
2.1. Key Features
The 16bit high speed microprocessor adoption enables the scope to acquire a typical 100,000 points per second and
quickly update the picture on the screen.
Basic memory length is 32kB. Captured waveforms can be zoomed in and analyzed in detail. Also its built-in 10ns
peak detection circuit enables it to capture high frequency noise even at a low speed time/div and magnify and
analyze it using the zoom-in function.
In addition, it can save up to 10 waveforms and provide diversified analysis function like FFT which is available on high
priced products.
®
Models PeakTech 1160/1165/1170 have a 15 cm width LCD-Colour-Display with 320x240 Pixel, models PeakTech
1145/1150/1155 have a Monochrome-Display.
2.2. General Features
- 80MHz bandwidth(PeakTech
- 150MHz bandwidth(PeakTech
- 250MHz bandwidth(PeakTech
- 100MS/s simultaneous maximum sampling rate per channel,
200MS/s sampling rate for one channel only
25GS/s equivalent sampling rate per channel
- 10ns peak detection for glitch capture even in ROLL mode
- Max. 400Vpp input voltage into all channels
2.3. Convenient Functions
- Direct single trigger capture function using a hot-key
- Simultaneous 5 waveform information auto measurement and FFT analysis
- Auto trigger level setting to 50%
- Saving 10 waveforms & 10 setup parameters
2.4. Operating Environment
This instrument will operate to its specifications if the environment is maintained within the following
conditions.
- Indoor use
- Altitude up to 2000m use
- Operating temperature 0 ~ 40°C
Relative humidity ≤ 80%
-
- Main supply voltage fluctuations not exceed 10% of the nominal voltage.
- After turning on the instrument, please allow a pre-heating period of as long as some 15 minutes.
2.5. Safety Symbols
Refer to accompanying documents for Safety-related information. Wherever the symbol is present,
see "NOTES FOR A SAFETY OPERATION" part in this manual.
Ground
WARNING max. Input Voltage 400 Vp
WARNING:
Risk of hazard which may cause injury to human body or danger to life. If a WARNING appears on the instrument, and
in this manual, do not proceed until its suitable conditions are understood and met.
CAUTION
Risk of hazard which causes fire or serious damage to the instrument or other equipment. Do not proceed until its
suitable conditions are met.
®
1145/1160), 2 CH dual digitizer
®
1150/1165), 2 CH dual digitizer
®
1155/1170), 2 CH dual digitizer
-2-
®