Assembly Of Hydraulic Line; Peristaltic Pump; Replacing The Peristaltic Hose - ECOLAB ECOPLUS S series Betriebsanleitung

7.9

Assembly of hydraulic line

 New hydraulic line
with packed connecting nipples [52].
WARNING
 Guide hydraulic line
[53] in back wall of housing.
 Pull hydraulic line
above the solenoid valve.
 Turn and guide hydraulic line
position relative to pipe interruptor.
 Remove protective packaging from both connecting
nipples.
WARNING
 Slide connecting nipple
interruptor [30].
(also refer to section
 Clip the pipe interruptor
into the holder [32].
7.10

Peristaltic pump

7.10.1

Replacing the peristaltic hose

 Unscrew and remove the suction/pressure line
 Swivel lever
 Pull pump housing
Fig. 7.49
417102228_Ecoplus-S
[51] (module spare part) is supplied
Never bend the connecting hose [51].
Do not turn connecting nipple in tube.
Do not remove protective packaging from
connecting nipple until hydraulic line is
correctly positioned in the unit.
[51] from below up through aperture
[51] upwards and sideways out of shaft
[51] into correct installation
Fragile hydraulic lines.
Never bend of apply force.
Connecting nipples must not be turned inside
the tube. Do not degrease, soil or damage the
O-rings.
[52] fully into the dismantled pipe
7.5.1 'Removal'.
[30] and connecting nipples
[53] upwards (Fig. 7.48).
[54] upwards to remove (Fig. 7.48).
 Remove peristaltic hose [55].
Do not twist hose while doing so.
 Clean pump housing, base plate
and rotor [56].
 Grease new peristaltic hose
rotor [56] with silicone grease.
 Install lubricated peristaltic hose
pump housing.
 Unscrew and remove the
suction/pressure line
- 46 -
Fig. 7.43
Fig. 7.45
Fig. 7.46
Fig. 7.47
[52]
Fig. 7.48
[55] and
[55] in
Fig. 7.44
Rev 01-08.12