Inserting The Electronics Module - ECOLAB ECOPLUS S series Betriebsanleitung

Special feature of the 'D' version
(transformer with connector)
 Route cable through cable screw connection
(see Fig. 7.16, item 23)
 Slide connector on PCB into bush
an audible 'click'.
Removal of connector
Press the clamp rocker
to on the connector to
release the connection
and remove the
connector.
 Use cable ties to control the cabling inside the unit.
WARNING
7.4.3

Inserting the electronics module

 Slide electronics module
both sides engage.
 Move all the connecting leads
outwards so that the funnel shaft
and no cables can be damaged.
 Ensure that the round cord seal
electronics housing cover
positioned.
 Press on the cover of the electronics housing
the front, ensuring the catches are correctly positioned.
 Press on the cover until all four catches audibly click
into place.
417102228_Ecoplus-S
[27] until it engages with
Fig. 7.19
CAUTION
The aperture for the funnel
(see Fig. 7.8, item [16]) must remain free.
[22] into unit from the front until
[15] inside the unit
[16] is kept clear
[28] in the
[29] is correctly
- 42 -
Fig. 7.18
Fig. 7.20
Fig. 7.21
Fig. 7.22
Fig. 7.23
Fig. 7.24
Fig. 7.25
[29] from
Never pull the
cable because it
would
otherwise
release from the
connector.
Rev 01-08.12