Removal; Recommended Procedure - ECOLAB ECOPLUS S series Betriebsanleitung

8

Removal

The following disassembly description is the recommended method.
NOTE
In practice, however, the actual assembly and installation processes are determined by
various conditions and by physical situations.
Because of the risk of chemical burns, the specified protective clothing (safety goggles,
safety gloves and, where applicable, apron) must be worn during work on parts that
come into contact with dangerous products.
CAUTION
All current international, national and regional safety regulations must be observed in
relation to the electrical connection of the Ecoplus S unit.
For work on the power connection, isolate it first (i.e. shut down power).

Recommended procedure

 Electrically isolate the unit (i.e. shut it down).
 Remove the cleaner capsule.
 Remove chemical residue from the funnel, e.g. by cleaning in DW.
 Install empty chemical capsules, reconnect device to power source and operate for a
few minutes with clean water.
 Close the water inlet (using angle valve or similar) and remove the connection.
 Disconnect device from its power source.
 Drain unit completely and clear all chemical residue from inside the unit.
 Either dispose of unit in accordance with applicable national directives or package
safely (cardboard box with padding material) and return to the Ecolab-authorized
company for recycling.
417102228_Ecoplus-S - 48 -
Rev 01-08.12