Electronics Housing; Removal; Electronics Wiring/Power Supply - ECOLAB ECOPLUS S series Betriebsanleitung

7.4

Electronics housing

7.4.1

Removal

 On one side, press both catches on the electronics
housing
from the front of the fastening device.
 Then press both catches
remove the housing cover from the top.
The PCB [20]
NOTE
7.4.2

Electronics wiring/power supply

 Press catch on one side
module [22]
 Then press down on other side of catch
disconnect/remove the electronics module
side.
 Remove the electronics module
forwards.
 Disconnect the electronics module [22], letting it hang down
at the front.
The cable screw connections are now freely accessible.
 The cable screw connection
supply purposes.
Connection of power supply (transformer cable [24])
Route the transformer cable
[24] through the cable screw
connection (see Fig. 7.16,
item 23) and connect it.
No. Description
24
Transformer cable
25 Screw fitting
26
Seal
417102228_Ecoplus-S
[19] and, using pressure, release the housing
[19] on the other side and
is now freely accessible.
The connection and program switch diagram
are located in the electronics housing!
[21] and pull electronics
out of fastening device.
[23]
Fig. 7.13
Fig. 7.14
Fig. 7.15
[21 l] and
[22] on this
[22] by pulling it
Fig. 7.16
is provided for power
Fig. 7.17
WARNING
- 41 -
Leave enough clearance
on the connecting lines to
enable the electronics
module to hang free and
with no tensile loading. At
the same time, always
take care to ensure that
no cable loops form.
Rev 01-08.12