Siko AP10 Originalmontageanleitung Seite 29

AP10
Commissioning
Manual setup operation
After applying supply voltage (see chapter 4.2), the position indicator will
be on the uppermost level of the menu structure (default/delivery state).
• Pressing the
• Pressing the
• Pressing the
LED displays
In the basic state (factory setting), the LED display has the following
meaning.
Color
both LED
green
one LED
red
both LED
red
Konfiguration
The required parameters are set in the configuration mode. On the 1st line
of the display, the parameter will be shown and on the 2nd line the res-
pective value will be displayed.
By actuating the
position in case of multi-digit values, or else completely (e. g. "500" ->
"1000").
The
numbers.
By pressing the
volatilely. If no key is pressed, the configuration mode will be exited after
~30 s without saving the latest value displayed, i. e. the original value will
be maintained.
AP10 · Date 25.09.2014 · Art. No. 86832 · Mod. status 356/14
key enables or disables the incremental measurement
function.
key starts calibration (see User manual).
key starts the parameter / programming mode (see
User manual).
State Description
on Actual position value is within the programmed
position window.
off Actual position value is outside the programmed
position window.
on Actual position value is outside the programmed
position window. The red LED indicates the direc-
tion of shaft rotation required to arrive at the set-
point.
off Actual position value is within the programmed
position window.
key, the current value can be changed at the blinking
key serves for switching to the next digit in case of multi-digit
key, the set value is acknowledged and saved non-
English 29