Changing The Battery Unit - Siko AP10 Originalmontageanleitung

AP10
32 Battery change
CAUTION

6.3 Changing the battery unit

Position indicator failure
Improper installation results in loss of type of protection.
` Evenly tighten the screws
aligned with the LCD housing
` Check the correct position of the O-ring
Preparation:
1. Connect position indicator to supply voltage.
2. Place the replacement battery unit ready (see chapter 6.1).
3. Place a Phillips screwdriver ready (e. g. PH 0x60).
Deinstallation (see Fig.
1. The battery compartment is situated on the left side of the device
(connections below).
2. Unscrew 3 fastening screws
3. Take out the battery unit
battery).
Installation (see Fig.
1. Insert new battery unit
2. Check the correct position of the O ring
tery unit, 2 the O-ring must lie all round the battery housing.



Fig. 9: Battery change
AP10 · Date 25.09.2014 · Art. No. 86832 · Mod. status 356/14
until the battery unit
1
4 .
9):
.
1
2 (refer to chapter
9):
2 . Take care that it can be inserted easily.

English
is completely
2
3 .
7
for disposal of the old
. When mounting the bat-
3
Screw
1
2 Battery unit
3 O ring
Housing
4