Herunterladen Inhalt Inhalt Diese Seite drucken

Disposal; Troubleshooting - MC Crypt L4S Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

12. Maintenance
Always observe the following safety information before cleaning or servicing the device:
The device is maintenance-free and you should therefore never open it. Live components may
be exposed if covers are opened or components are removed. If you open the device, the gua-
rantee will expire.
All connected devices must be disconnected from the mains before servicing or repairs.
Only qualified experts familiar with the hazards involved and the relevant regulations must per-
form repairs.
Clean the exterior of the device with a soft, dry cloth or brush only. Never use any aggressive cleaning agents or
chemical solutions that may damage the surface of the casing.
Only then plug in the mains adapter into the mains socket again.

13. Disposal

Electronic devices are recyclable waste and must not be disposed of in the household waste!
At the end of its service life, dispose of the product according to the relevant statutory regulations.

14. Troubleshooting

By purchasing this device, you have acquired a product designed to the state of the art and operationally reliable.
Nevertheless, problems or errors may occur. The following contains descriptions for the removal of possible inter-
ference.
Always observe the safety information!
No function after the mains adapter was plugged into the mains socket.
The mains adapter is not plugged into the mains socket correctly.
The mains adapter's low-voltage plug is not correctly connected to the mixer's low-voltage plug.
No signal is played back via the MAIN sockets.
The MAIN slider is not set correctly.
Verify the cables connected to the MAIN sockets.
The volume control of the PA-amplifier is set to "MINIMUM".
A channel is not played back via the MAIN sockets.
Check the cable connected to the channel input.
Is a signal present at the channel input? Check the signal source.
The GAIN control or the channel's channel slider are not set correctly.
The INSERT socket is used. The connected effect device is not switched on.
35

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis