(Helps You To Quickly Solve Any Problems You May Encounter While Using The Machine) - Efco ARTIK 56 EL Betriebs- Und Wartungsanleitung

WARNING: always stop the machine and remove the engine key (5, Fig. 41) before carrying out any of
I
the corrective checks recommended in the table below, except when they require the unit to be in
operation.
When all the possible causes have been checked and the problem is not resolved, consult an Authorised Service
Centre. If a problem occurs that is not listed in this table, consult an Authorised Service Centre.
GB
Problem
Engine fails to start
F
D
Engine starts,but runs poorly
E
Drop in power of the engine
SK
Cutter does not rotate
P
GR
Cutter does not stop when the lever is
TR
released.
N O T E : Tu r n o f f t h e e n g i n e
immediately
The traction does not work
CZ
Traction does not stop when the lever
is released.
N O T E : Tu r n o f f t h e e n g i n e
RUS
UK immediately
The machine veers to one side
PL
The machine has strong vibrations.
N O T E : Tu r n o f f t h e e n g i n e
immediately
WARNING: Do not attempt to carry out repairs without the necessary repairs and technical expertise.
Poorly executed repairs will automatically invalidate the warranty and relieve the manufacturer of all
liability.
44
11. TROUBLESHOOTING
Possible causes
There isn't gasoline
Engine flooded
Water in gasoline or old gasoline
Spark plug dirty or defective
Low battery (56 EL)
Other
Spark plug defective
Gasoline cap vent is blocked
Snow chute clogged
Cutter and impeller clogged or
frozen
Speed to high
Foreign bodies obstructing it
Shear pins broken
Cutter control cable incorrectly
adjusted
Drive belt cutter slide
Drive belt cutter broken
Drive belt cutter incorrectly adjusted To adjust the belt in an Authorized
Pulley of the drive belt cutter
incorrectly adjusted
Traction control cable incorrectly
adjusted
Drive belt trac tion incorrec tly
adjusted
Pulley of the drive belt traction
incorrectly adjusted
Tires pressure not equal
Skid plates incorrectly adjusted
Scraping blade incorrectly adjusted
There's traction on one wheel
Cutter and impeller damaged
Solution
Fill the gasoline tank
See the procedure pag.36
Drain tank and refil with fresh
gasoline
Clean or replace
Recharge (pag.28)
Check carefully the start procedure
according to this manual, pag.35
Replace
Clean the vent
Clean (pag.37)
Clean
Enter a lower gear (pag.37)
Clean
Replace (pag.40)
Adjust the cable (pag.40)
To adjust the belt and the pulley in
an Authorized Service Center
Replaced in an Authorized Service
Center
Service Center
To a d j u s t t h e p u l l e y i n a n
Authorized Service Center
Adjust the cable (pag.40)
To adjust the belt in an Authorized
Service Center
To a d j u s t t h e p u l l e y i n a n
Authorized Service Center
Adjust the tires pressure (pag.34)
Adjust the skid plates and the
scraping blade (pag.33)
Adjust the scraping blade and the
skid plates (pag.33)
C h e c k t h e m a c h i n e i n a n
Authorized Service Center
C h e c k t h e m a c h i n e i n a n
Authorized Service Center