Operation - Abicor Binzel ROBO Compact W600 Betriebsanleitung

7 Operation

6.4 Feeding in the wire
7 Operation
EN - 16
CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
NOTICE
• Each time the wire is replaced, make sure that the start of the wire is free
of burrs and not bent.
1 Lay the cable assembly connected to the machine out straight.
2 Insert the wire into the wire feed unit as specified by the manufacturer.
3 Press the "zero-current wire feed" trigger on the wire feeder until the wire
emerges from the contact tip.
DANGER
Shortness of breath and poisoning caused by inhaling
phosgene gas
When welding workpieces that have been degreased with chlorinated
solvents, phosgene gas is formed.
• Rinse the workpieces with clean water prior to welding.
• Do not inhale smoke and vapours.
• Ensure a sufficient supply of fresh air.
• Do not place degreasing baths containing chlorine in the vicinity of the
welding area.
DANGER
Risk of burns
During welding, sparks, glowing workpieces or hot slag can produce flames.
• Check the work area for flashpoints.
• Provide appropriate fire extinguishing equipment in the workplace.
• Allow workpieces to cool down after welding.
• Prior to performing welding work, properly fasten the ground clamp to
the workpiece or welding table.
ROBO Compact W600