Herunterladen Inhalt Inhalt Diese Seite drucken

Abicor Binzel ROBO Compact W600 Betriebsanleitung Seite 51

Vorschau ausblenden Andere Handbücher für ROBO Compact W600:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
ROBO Compact W600
Fault
Cause
• Contact tip loose
Torch neck gets
• Contact tip loose on the torch and
hot
• Coolant flow too low
• Control lead interrupted/defective
No trigger
• Flow control in the coolant
function
Wire burned
• Wrong parameters set
solid in the
• Contact tip worn out
contact tip
• Spiral liner/PA liner clogged
Irregular wire
• Contact tip and wire diameter not
feed
• Wrong contact pressure set on the
Arc between the
• Spatter bridge between the contact
gas nozzle and
the workpiece
• Contact tip not aligned to the wire
Erratic arc
• Wrong welding parameters set
• Wire guide unit worn out
• Strong weld spatter build-up in the
• Insufficient or no gas coverage
Pore formation
• Air current blows shielding gas
Tab. 13
Troubleshooting
toward the workpiece
recirculator has triggered
aligned
wire feeder
tip and the gas nozzle
diameter or contact tip diameter
enlarged
gas nozzle
away
10 Troubleshooting
Troubleshooting
• Check and tighten
• Check and tighten
• Check the cooling system
• Check/repair
• Check the coolant level and top up if
necessary
• Check and correct setting
• Replace
• Clean both directions with compressed
air or replace if necessary
• Replace contact tip
• Correct as specified by the manufacturer
• Clean and spray the gas nozzle interior
• Check the contact tip
• Correct the welding parameters
• Replace the wire guide
• Clean the gas nozzle
• Check the gas cylinder contents and
pressure setting
• Use partitions to shield the welding area
EN - 25

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis