Abicor Binzel ROBO Compact W600 Betriebsanleitung Seite 49

ROBO Compact W600
9.5 Cleaning the wire brake (optional version with wire brake)
1
1 Torch neck
Fig. 9 Cleaning the wire brake
Carry out each step in accordance with the figure below:
B
D
1 Unscrew the complete wire brake (2) from the torch neck (1).
WARNING
Risk of injury
Serious injuries can be caused by parts swirling around.
• When cleaning the wire guide with compressed air, always wear
personal protective clothing, in particular safety goggles.
2 Disassemble individual parts and air-blast with compressed air.
3 Check the O-rings for wear and replace them if necessary.
4 Grease the piston and O-rings with seal grease (included in the scope
of delivery).
5 Remount all individual parts in the reverse order.
9 Maintenance and cleaning
A
C
2 Wire brake, complete
2
EN - 23