Welding Process; Putting Out Of Operation - Abicor Binzel ROBO Compact W600 Betriebsanleitung

ROBO Compact W600

7.1 Welding process

8 Putting out of operation

WARNING
Arc eye
The arc produced by welding can damage the eyes.
• Wear your personal protective equipment.
• Check the personal protective equipment before every cutting process.
NOTICE
• The device must only be operated by qualified personnel (in Germany,
see TRBS 1203).
• Never pull the cable assembly across sharp edges or place it in the weld
spatter area or on hot workpieces.
• As the ROBO Compact W600 is integrated into a welding system, the
operating instructions of the welding components, such as power source,
must be observed during operation.
• Ensure that all required parameters, for example welding current, wire
feeder, etc., have been set at the welding power source according to
your welding task.
1 Open the shielding gas cylinder and switch on the power source.
2 Set the welding parameters.
3 Start welding.
NOTICE
• As liquid-cooled cable assemblies start to leak when they overheat, the
cooling unit should continue running for approx. 5 min. after welding.
• When putting the system out of operation, ensure that the procedures for
switching off each of the welding system components are observed.
1 Stop welding.
2 Wait until the shielding gas post-flow time has passed and then switch off
the power source.
3 Close the valve on the shielding gas cylinder.
8 Putting out of operation
EN - 17