Drive Chain Slack - Benelli TRK 502 Bedienungsanleitung

Periodic maintenance and adjustment

Drive chain slack

The drive chain slack should be checked befo-
re each ride and adjusted if necessary.
To check the drive chain slack
EN
1. After stopping the engine, place the vehi-
cle on a rear stand on a horizontal surface and
with the gear in neutral.
6
2. Measure the drive chain slack as shown.
Drive chain slack:
10 - 15 mm (0.40 - 0.60 in)
3. After running the rear wheel forward occur
else where in the free play chain: it must be
constant.
4. If the drive chain slack is incorrect, adjust it
as follows.
NOTICE
Using the motorcycle with the chain in bad
condition and badly adjusted may cause
accidents.
If you notice any operating anomaly on the
chain, such as excessive or suspicious noi-
ses, or excessive slack, go to an authorised
Benelli workshop.
If you suspect that there is a serious mal-
function with the chain, stop the bike im-
mediately and call your nearest Benelli au-
thorised workshop.
6 - 22
To adjust the drive chain slack
1. Loosen the wheel pin nut and lock nut on
each side of the swingarm.
2. To tension the transmission chain, turn the
tension adjustment bolt on each side of the
swingarm (clockwise).
3. To loosen the transmission chain, turn the
tension adjustment bolt on each side of the
swingarm (anticlockwise) and push the rear
wheel forwards.
3
1
4
1. Axle nut
2. Locknut
3. Drive chain slack adjusting bolt
4. Distance
2