Benelli TRK 502 Bedienungsanleitung Seite 116

ABS button
Do not try to adjust settings of ABS while the
motorcycle running. The ABS settings are not
enabled when the vehicle speed is above 5
km/h.
Disabling ABS
Make sure the motorcycle is stationary and
in neutral. Keep the ABS button pressed for
3-5 seconds, the light will switch from steady
to flashing for about 1.30 seconds (short fla-
shing). At this stage, the ABS system will be
not active and the braking system will conti-
nue working as a normal system not equip-
ped with ABS.
ABS
Enabling ABS:
Make sure the motorcycle is stationary and
in neutral. Keep the ABS button pressed for
3-5 seconds, the light will switch from steady
to flashing for about 1.30 seconds (short fla-
shing). Another way for enabling the ABS sy-
stem is to switch off and then on again.
A: the procedure will be ignored by the sy-
stem if the ABS button was pressed for a time
ranging from 5 and 30 seconds.
~
The ABS will keep the current settings.
~
ABS
~
ABS
3 - 7
Instrument and control functions
B: The ABS will be active again from any other
previous setting when the button is pressed
for a time longer than 30 secs.
ABS
EN
3