Handlebar Switches - Benelli TRK 502 Bedienungsanleitung

Instrument and control functions

Handlebar switches

Left
EN
3
1. Horn switch " "
2. Dimmer/switch " /
3. Turn signal switch "
4. Passing button
5. ABS switch
ABS
Righ
4
2
5
ABS
3
1. Run/Start switch "
1
2. Hazard switch " "
3. Electric ignition button
"
Horn switch "
"
Press this switch to sound the horn.
Dimmer/switch "
Set this switch to "
to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this switch
to " ". To signal a left-hand turn, push this
switch to "
returns to the center position.
To cancel the turn signal lights, push the swi-
tch in after it has returned to the center po-
sition.
1
2
3
/ "
"
/ "
" for the high beam and
/ "
". When released, the switch
3 - 6
Passing button
Press this button (daytime) to enable lashing
lights.
Run/Start switch " / "
To crank the engine with the starter, set this
switch to " ", See page 5-1 for starting in-
structions prior to starting the engine.
Set this switch to " " to stop the engine in
case of an emergency, such as when the vehi-
cle overturns or when the throttle cable is
stuck.
Hazard switch " "
With the ignition key set to " " use this switch
to switch on the emergency lights (simultane-
ous lashing of all of the direction indicators).
The emergency lights are used in case of
emergency, to advise the other road users
that your vehicle is about to stop in dange-
rous trafic areas.
WARNING
Do not use the emergency lights when
the engine is off; this is to stop the battery
from becoming flat.
Electric ignition button
Press this button to start the engine with the
starter device.