Benelli TRK 502 Bedienungsanleitung Seite 147

Periodic maintenance and adjustment
8. Install the engine oil drain bolt and its new
gasket, and then tighten the bolt to the spe-
cified torque.
Tightening torque:
Engine oil drain bolt:
EN
22 N·m (2.2 kgf·m, 16.2 lb·ft)
6
9. Refill with the specified amount of the re-
commended engine oil, and then install and
tighten the oil filler cap.
Recommended engine oil:
PETRONAS POWER SPEED 4T
Oil quantity:
Oil change:
2.8 L (0.73 US gal, 0.61 Imp gal)
With oil filter removal:
3.0 L (0.80 US gal, 0.65 Imp gal)
TIP
Be sure to wipe off spilled oil on any parts
after the engine and exhaust system have co-
oled down.
NOTICE
• In order to prevent clutch slippage
(since the engine oil also lubricates
the clutch), do not mix any chemical
additives. Do not use oils with a diesel
specification of "CD" or oils of a higher
quality than specified. In addition, do
not use oils labeled "ENERGY CON-
SERVING II" or higher.
• Make sure that no foreign material
enters the crankcase.
10. Start the engine, and then let it idle for se-
veral minutes while checking it for oil leakage.
If oil is leaking, immediately turn the engine
off and check for the cause.
TIP
After the engine is started, the engine oil level
warning light should go off if the oil level is
sufficient.
NOTICE
If the oil level warning light flickers or re-
mains on even if the oil level is correct, im-
6 - 12
mediately turn the engine off and have a
Benelli dealer check the vehicle.
11. Turn the engine off, wait a few minutes un-
til the oil settles, and then check the oil level
and correct it if necessary.