Checking And Lubricating The Cables; Checking And Lubricating The Throttle Grip And Cable; Checking And Lubricating The Brake And Shift Pedals - Benelli TRK 502 Bedienungsanleitung

Periodic maintenance and adjustment

Checking and lubricating the cables

The operation of all control cables and the
condition of the cables should be checked be-
fore each ride, and the cables and cable ends
should be lubricated if necessary.
EN
If a cable is damaged or does not move smo-
othly, have a Benelli dealer check or replace it.
6
WARNING
Damage to the outer housing of cables
may result in internal rusting and cause in-
terference with cable movement.
Replace damaged cables as soon as possi-
ble to prevent unsafe conditions.
Checking and lubricating the throttle
grip and cable
The operation of the throttle grip should be
checked before each ride. In addition, the
cable should be lubricated by a Benelli dealer
at the intervals specified in the periodic main-
tenance chart.
The throttle cable is equipped with a rubber
cover. Make sure that the cover is securely
installed. Even though the cover is installed
correctly, it does not completely protect the
cable from water entry.
Therefore, use care not to pour water direct-
ly onto the cover or cable when washing the
vehicle. If the cable or cover becomes dirty,
wipe clean with a moist cloth.
6 - 24
Checking and lubricating the brake
and shift pedals
The operation of the brake and shift pedals
should be checked before each ride, and the
pedal pivots should be lubricated if necessary.
Brake pedal