Handlebar Switches - Benelli LEONCINO 800 2021 Bedienungsanleitung

Handlebar switches

Left
1. Horn switch
2. Optional
3. Dimmer/switch
4. Turn signal switch
Right
3
2
4
1
1. Run/Start switch
2. Hazard switch
3. Electric ignition button
4. Light mode switch
Horn switch
Press this switch to sound the horn.
Dimmer/switch
Set this switch to "
and to " " for the low beam.
Turn signal switch
To signal a right-hand turn, push this swi-
tch to " ". To signal a left-hand turn,
push this switch to "
the switch returns to the center position.
To cancel the turn signal lights, push the
switch in after it has returned to the cen-
ter position.
Instrument and control functions
Run/Start switch
To crank the engine with the starter, set
this switch to " ", see page 5-1 for star-
ting instructions prior to starting the en-
1
gine.
Set this switch to " " to stop the engine in
case of an emergency, such as when the
4
vehicle overturns or when the throttle
2
cable is stuck.
3
Hazard switch
With the ignition key set to " " use this
switch to switch on the emergency lights
(simultaneous lashing of all of the di-
rection indicators).
The emergency lights are used in case of
emergency, to advise the other road users
that your vehicle is about to stop in dan-
gerous tra c areas.
Light mode switch
Allows you to select the lights for night
/
driving or daytime driving (DLR).
" for the high beam
Do not use the emergency lights when
the engine is o ; this is to stop the bat-
". When released,
tery from becoming at.
Electric ignition button
Press this button to start the engine with
the starter device.
3 - 7
WARNING
EN
3