GGP ITALY 98SD Gebrauchsanweisung Seite 58

16
EN
Hydrostatic transmission
4.31 BRAKE PEDAL
This pedal works the brake on the rear wheels.
4.32 DRIVE PEDAL
This pedal engages drive in the wheels and controls the machine's forward and
reverse speeds.
– To engage forward drive, press it towards «F» with your toe-cap. As you increase
the pressure on the pedal, the speed of the machine increases.
– Reverse is engaged by pressing the pedal with the heel towards «R».
– The pedal automatically goes into neutral «N» when released.
WARNING!
moving
NOTE
engine stops as soon as the parking brake (4.4) is engaged.
4.33 HYDROSTATIC
TRANSMISSION
DISENGAGEMENT
LEVER
This lever has two positions as
shown on the label:
«A» = Transmission engaged:
for all uses, when mov-
ing and during cutting;
«B» = Transmission disen-
gaged: this makes it
much easier to move
the machine by hand,
with the engine
turned off.
IMPORTANT
damage to the transmission
unit, this operation must be
carried out only when the
engine has stopped with the
pedal (4.32) on position «N».
Only shift into reverse when the machine has stopped
If the drive pedal is used, whether forwards or for reverse, the
To avoid
CONTROLS AND INSTRUMENTS
4.32
N
R
4.33
4.31
F
B
A