End Of Work; Cleaning The Machine - GGP ITALY 98SD Gebrauchsanweisung

24
EN
Whatever the conditions, always reduce the speed if you notice a drop in engine speed
if you travel too fast compared to the amount of grass being cut, you will not be able
to mow the grass well.
Disengage the blades and raise the cutting deck as high as possible whenever you
need to get past an obstacle.
5.4.6 End of mowing
When you have finished mowing, disengage the blades, lower the engine speed and
ride the machine with the cutting deck raised as high as possible.

5.4.7 End of work

Stop the machine, move the throttle to «SLOW» and turn
off the engine by turning the key to «OFF».
When the engine has stopped, close the fuel stopcock (1)
( if fitted).
WARNING!
throttle on «SLOW» for 20 seconds before stopping
the engine.
WARNING!
before leaving the machine unattended!
IMPORTANT
position when the engine is not running.

5.4.8 Cleaning the machine

After each mowing, clean the outside of the machine, empty the grass-catcher and
shake it to remove residual grass and earth.
WARNING!
full of cut grass inside a room.
Clean the plastic parts of the body with a damp sponge using water and detergent,
taking care not to wet the engine, the electrical parts or the electronic card located
under the dashboard.
To avoid backfire, position the
Always take out the ignition key
To keep the battery charged, do not leave the key in the «ON»
Always empty the grass-catcher and do not leave containers
HOW TO USE THE MACHINE
1