Changing The Sealing Blade; Wiring Diagram; Disassembling, Demolition And Elimination Of Residuals - Minipack-Torre Media Matic Installations-, Gebrauchs- Und Wartungsanleitung

Chapter 7. Ordinary maintenance

7.8. Changing the sealing blade

To replace the sealing blade (19) follow this procedure:
Disconnect power to the machine

Unscrew the three screws (20), (21), (22)

Remove the old sealing blade

Clean the housing and if necessary replace the

insulating teflon (23) of the central clamp
Insert the new sealing blade starting from the central

clamp and tighten the screw (21)
Trim the new sealing blade according to the holes of

the pistons (24) and (25)
Complete the insertion if the sealing blade in the whole

housing
Push the rear piston completely onwards (25) towards

the sealing blade to make it enter the hole of the piston
itself and then tighten screw (22)
Insert a tool (for example a screwdriver) in hole (18)

and push front piston (24) towards the sealing blade to
enter the hole of the piston itself, then tighten screw
(20)
Trim the teflon projecting from the central clamp

Make sure that the sealing blade (19) is properly

positioned and tight.

7.9. Wiring diagram

B1 Frame lowering limit switch
B2 Frame lifting limit switch
B3 Frame safety device cutting out limit switch
B5 Frame safety limit switch
B6 Rewinder limit switch
BT1 Thermocouple
E1/2 Cooling fan
ER1 Cutting resistance
ER2 Heater
ER3 Heater
ER4 Heater
F1 Sealing blade / heaters fuse
F2 Fan / belt / frame motor fuse
F3 Auxiliary transformer fuse
F4 Ventilator / pump motor fuse
FU1 Board fuse 5X20
K1 Power board
M1 Fan motor
M2 Belt motor
M3 Frame drive motor
M4 Belt oven motor

7.10. Disassembling, demolition and elimination of residuals

ATTENTION!
All disassembling and demolition operations must be done by qualified personnel with mechanical and
electrical expertise required to work in safe conditions.
Proceed as follows:
Disconnect machine from power mains

Disassemble components.

All wastes must be treated, eliminated or recycled according to their classification and to the procedures in
force established by the laws in force in the country where the equipment has been installed.
The symbol indicates that this product shall not be treated as household waste. By making sure that the
product will be properly disposed of, you will facilitate the prevention of potential negative effects for the
environment and human health, which might be otherwise caused by the improper waste treatment of this
product. For more detailed information about the recycling of this product, please contact the product
seller or, as an alternative, the after-sales service or the corresponding waste treatment service.
(page 77/78).
10.3X38
10.3X38
10.3X38
5X20
M5 Ventilator motor
M6 Rewinder motor
Q1 Main switch
Q2 Rewinder switch
QM1 Cutting contactor
QM2 Heaters contactor
QM3 Fan contactor
QM4 Sealing belt contactor
QM5 Frame descent contactor
QM6 Frame rise contactor
QM7 Accessories contactor
S0 Emergency pushbutton
S1 Start button
S2 Manual selector
S3 Foot pedal (optional)
SK1 Control board
T1 Cut transformer
T2 Auxiliary transformer
TS1 Inverter
X1 Rewinder power supply socket
X2 Rewinder power supply plug
29
EN